The most important lubricants of the vehicles generally perform two major functions, which is lubricating and cleaning. A lot of dirt as well as metal savings would get accumulated with time, so the fluid makes sure to circulate them through the parts. All this waste material or debris would simply settle down at the bottom and would not circulate through the system. This is the reason why a lot of auto shops use machines which are specially designed to perform a transmission fluid flush. This would ensure you that the debris is now removed before you pour any new transmission fluid into your vehicle.
If you want to increase your vehicle’s life, then you must do regular fluid changes. The general service interval which is recommended is about 30,000 miles. You can always check your car’s owner manual if you get trapped anywhere. If the dipstick of your car’s automatic transmission fluid turns dark or shows some burnt smelling fluid, then it should be changed as soon as possible.
DIY Transmission Fluid and Filter Changes
Most of the people think that changing the fluid can be a messy task a lot of transmission pans don’t have drain plugs and the entire pan should be removed. But, even the vehicles which have drain plugs; the filter is changed by removing the pan.
If you will change the transmission fluid all by yourself, then you would save a lot of money as well as time. Your gearbox would become young and provide better performance.
Steps to change your automatic transmission fluid
If you have some patience, then learning how to change your car automatic transmission would benefit you a lot in the long run. For this task you will require an automatic transmission kit and some basic shop tools. Follow these steps mentioned below:
- Let your car sit idle for a few minutes as the transmission fluid would then drain better. Raise and secure your vehicle, once you have turned the ignition off. Then remove the bolts from one side of the transmission pan and maintain distance from hot exhaust parts and fluid.
- Now loosen the other bolts and then start draining. After removing all the bolts, dump the remaining fluid into the catch pan.
- Carefully clean the gasket surfaces on the pan as well as on the transmission housing. You can check the pan if there are any sort of metal shavings or some other signs of internal damage.
- Remove the old transmission filter and the filter would contain some fluid, so keep the drain path underneath.
- Install your new transmission filter and make sure that the O ring is seated in the appropriate place.
- Now you have attach your new gasket to the pan
- You can refer to your service manual when you will be using your thread sealer on any of the transmission pan bolts
- Lower down your vehicle and then fill the transmission as per the recommended amount of fluid.
- Start your car and let it warm and then shut it off to check for leaks.
If you are willing to change your car parts all by yourself and want to buy new ones, then all you have to do is to visit our online auto parts store – https://partsavatar.ca/. We care for our customers and that’s why we offer the best quality of products at affordable prices.
